stroke adjustable cylinder(stroke adjustable cylinder,produced by Hengyu Hydraulic Co., Ltd）stroke adjustable cylinder are widely used ，because of smooth movement，high work efficiency，
(stroke adjustable cylinder,produced by Hengyu Hydraulic Co., Ltd）
stroke adjustable cylinder are widely used ，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed stroke adjustable cylinder for our customers.
stroke adjustable cylinder use should try to avoid sealing belt into the stroke adjustable cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the stroke adjustable cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the stroke adjustable cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.
The repair method of stroke adjustable cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.
In the case of serious wear on the inner surface of the stroke adjustable cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the stroke adjustable cylinder manufacturing process for replacement. The stroke adjustable cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.
Because of the slightly complex structure of the buffer stroke adjustable cylinder, sometimes there will be problems, such as when the stroke adjustable cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.
What are the connection methods of the hydraulic cylinder? The connection modes of the cylinder and the actuator are earring connection, hinge shaft connection, thread connection, etc. The connection modes of tubing and cylinder are threaded connection, flange connection, etc.
The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.
Add Wechat