hydraulic hollow cylinder Sold to Chile

This article mainly introduces:

Chile hydraulic cylinder,hydraulic hollow cylinder manufacturer,hydraulic hollow cylinder

(Chile hydraulic hollow cylinder,produced by Hengyu Hydraulic Co., Ltd）

hydraulic hollow cylinder are widely used in Chile，because of long service life，high work efficiency，smooth movement.So our company has designed hydraulic hollow cylinder for customers from Chile.

Introduction to hydraulic hollow cylinder:

When the oil pressure of the hydraulic hollow cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

The hydraulic hollow cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

When the hydraulic hollow cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the hydraulic hollow cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

hydraulic hollow cylinder hydraulic oil selection: The recommended working oil viscosity of the hydraulic hollow cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

Answers to some questions about hydraulic hollow cylinder:

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.

By what means can the hydraulic system control the arbitrary stroke position of the rotary cylinder piston rod?
The following ways can be considered: 1, through the limit device, such as limit switch, position sensor, etc. 2, by feedback the pressure of the hydraulic oil in the cylinder. The load determines the pressure, the pressure in the cylinder is determined by the load, and the pressure is very small when the cylinder is unloaded. 2.1 When clamping the workpiece, the pressure of the cylinder increases, by calculating the relationship between the clamping force and the pressure of the cylinder, take a pressure value of the cylinder, set the pressure switch, and drive the valve to work when the pressure reaches the preset value, so that the oil circuit stops supplying oil. 2.2 or set the pressure value of the relief valve to overflow after a certain set pressure.