<table id="kaokc"><wbr id="kaokc"></wbr></table>
  • <rt id="kaokc"><delect id="kaokc"></delect></rt>
    <rt id="kaokc"></rt>
  • <li id="kaokc"><source id="kaokc"></source></li>
  • <rt id="kaokc"><delect id="kaokc"></delect></rt>
    High quality hydraulic equipment manufacturers!
    TELL:+8613184968882

    trunnion cylinder Sold to Brazil

    Release time:2023-11-13 11:19:30 Hits: Current position: Home > News

    This article mainly introduces:

    Brazil hydraulic cylinder,trunnion cylinder manufacturer,trunnion cylinder

    Brazil trunnion cylinder

    (Brazil trunnion cylinder,produced by Hengyu Group)

    trunnion cylinder are widely used in Brazil,because of no transmission clearance,powerful torque,clever hydraulic energy conversion.So our company has designed trunnion cylinder for customers from Brazil.

    Introduction to trunnion cylinder:

    When the piston speed of the trunnion cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the trunnion cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

    Because of the slightly complex structure of the buffer trunnion cylinder, sometimes there will be problems, such as when the trunnion cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

    If air enters the hydraulic system, the trunnion cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

    Do not regularly check the damage of the chrome layer of the trunnion cylinder: completely extend the trunnion cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the trunnion cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the trunnion cylinder seal. Welding slag is strictly prohibited on the surface of the trunnion cylinder.

    Answers to some questions about trunnion cylinder:

    Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
    Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.

    What are the functions of hydraulic cylinders?
    Hydraulic cylinder is a hydraulic actuator, the specific role depends on the installation occasion and the type of hydraulic cylinder. Hydraulic cylinder is mainly used in machinery, and it is the most important component of construction machinery. It is important core component which mainly provide power for machinery.

    Back to list Recommended article

    Leave a message if you have any questions.

    Send
    Email

    Email:hsslrubbertech@gmail.com7x24 hours

    Glad to receive your consultation!:

    Service
    Tel

    +8613184968882
    7x24hours service

    Add
    Wechat

    Add Wechat
    TOP
    主站蜘蛛池模板: 夏河县| 平江县| 淳化县| 合阳县| 黄浦区| 丁青县| 康保县| 漳浦县| 巴马| 内江市| 英山县| 屏山县| 大庆市| 邵阳市| 滕州市| 措勤县| 右玉县| 肇州县| 潞城市| 侯马市| 英山县| 古田县| 成安县| 斗六市| 巴东县| 安阳县| 中卫市| 宜兰县| 沙湾县| 五莲县| 长宁县| 虹口区| 偃师市| 拉萨市| 二手房| 吉首市| 山东省| 金门县| 荆州市| 和静县| 高尔夫|