hydraulic lift cylinder Sold to Kuwait

This article mainly introduces:

Kuwait hydraulic cylinder,hydraulic lift cylinder manufacturer,hydraulic lift cylinder

(Kuwait hydraulic lift cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic lift cylinder are widely used in Kuwait，because of long service life，smooth movement，high work efficiency.So our company has designed hydraulic lift cylinder for customers from Kuwait.

Introduction to hydraulic lift cylinder:

The repair method of the hydraulic lift cylinder: the repair of the hydraulic lift cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

The definition of the minimum stable speed refers to the minimum movement speed of the hydraulic lift cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the hydraulic lift cylinder that undertakes different work has different requirements for the minimum stable speed.

The hydraulic lift cylinder is not the same as the hydraulic lift cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the hydraulic lift cylinder can not be used as a high-power power component, but the hydraulic lift cylinder can be used as a relatively large power component, or the hydraulic lift cylinder system can be used.

We can not just consider the price and ignore the quality when we purchase the hydraulic lift cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the hydraulic lift cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the hydraulic lift cylinder is not required.

Answers to some questions about hydraulic lift cylinder:

How to remove the cylinder correctly?
(1) Before disassembling the hydraulic cylinder, the hydraulic circuit should be depressurized. Otherwise, when the tubing joint connected with the cylinder is loosened, the high-pressure oil in the circuit will be quickly ejected. The hydraulic circuit of the hydraulic press should first loosen the hand wheel or pressure regulator screw at the relief valve, so that the pressure oil is unloaded, and then block the power supply or block the power source to stop the operation of the hydraulic equipment. (2) When disassembling, it should prevent damage to the top thread of the piston rod, the oil thread, the appearance of the piston rod, the inner wall of the cylinder liner, etc. In order to prevent the piston rod and other slender parts from twisting or deformation, the use of cushion wood support balance when placed. (3) Disassemble in order.

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.