reciprocating cylinder Sold to Kenya

This article mainly introduces:

Kenya hydraulic cylinder,reciprocating cylinder manufacturer,reciprocating cylinder

(Kenya reciprocating cylinder,produced by Hengyu Hydraulic Cylinder Factory）

reciprocating cylinder are widely used in Kenya，because of high work efficiency，excellent fatigue and impact resistance，smooth movement.So our company has designed reciprocating cylinder for customers from Kenya.

Introduction to reciprocating cylinder:

The reciprocating cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure reciprocating cylinder can use 20 steel pipe, and the high pressure reciprocating cylinder can use 45 steel pipe.

There are some honeycomb holes in the inner wall of the reciprocating cylinder, piston or piston rod surface. How is this formed? When we repair the reciprocating cylinder, we can see that there are some honeycomb holes on the inner wall of the reciprocating cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the reciprocating cylinder is targeted to prevent. Is very necessary.

In the case of serious wear on the inner surface of the reciprocating cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the reciprocating cylinder manufacturing process for replacement. The reciprocating cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Most of the failure of the reciprocating cylinder is because there is a foreign body in the reciprocating cylinder into the failure of the reciprocating cylinder, the most problematic is that it is difficult to determine when the foreign body is into the reciprocating cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about reciprocating cylinder:

What is hydraulic cylinder？ How to use hydraulic cylinder？ what is the application of hydraulic cylinder?
Hydraulic cylinder is the hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating movement (or swing movement). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides. The hydraulic cylinder is basically composed of cylinder body, cylinder head, piston, piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential. Hydraulic cylinders are mainly used in machinery.

To achieve the same stroke, which is better, hydraulic cylinder or lead screw?
If there is batch action, then the hydraulic pressure is better. Hydraulic: smooth operation, no lubrication, easy control, high control accuracy (can use proportional or servo system), the key is to manually control, but certainly to support the hydraulic system, for a single action must cost. Maintenance costs are also high. Lead screw: simple structure, easy to achieve, convenient maintenance, but must be lubricated, can not be manual, or manual control is inconvenient. See where it is used, if it is used in high-precision occasions, it must only be hydraulic, because the lead screw has a gap. There are many hydraulic actions, the hydraulic system itself must be prepared, then the use of hydraulic pressure is also very economical.