tilting furnace hydraulic cylinder Sold to Belarus

This article mainly introduces:

Belarus hydraulic cylinder,tilting furnace hydraulic cylinder manufacturer,tilting furnace hydraulic cylinder

(Belarus tilting furnace hydraulic cylinder,produced by Hengyu Group）

tilting furnace hydraulic cylinder are widely used in Belarus，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed tilting furnace hydraulic cylinder for customers from Belarus.

Introduction to tilting furnace hydraulic cylinder:

The quality of the tilting furnace hydraulic cylinder can not be ignored in the purchase of the tilting furnace hydraulic cylinder. The tilting furnace hydraulic cylinder is the main component of the tilting furnace hydraulic cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. tilting furnace hydraulic cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of tilting furnace hydraulic cylinder is deep hole processing, which has always troubled the processing personnel.

The piston seal of the tilting furnace hydraulic cylinder is the main element to prevent leakage in the tilting furnace hydraulic cylinder. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

The pressure of the sliding surface of the tilting furnace hydraulic cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the tilting furnace hydraulic cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

The tilting furnace hydraulic cylinder is not the same as the tilting furnace hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the tilting furnace hydraulic cylinder can not be used as a high-power power component, but the tilting furnace hydraulic cylinder can be used as a relatively large power component, or the tilting furnace hydraulic cylinder system can be used.

Answers to some questions about tilting furnace hydraulic cylinder:

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.