stainless steel cylinder Sold to Uzbekistan

This article mainly introduces:

Uzbekistan hydraulic cylinder,stainless steel cylinder manufacturer,stainless steel cylinder

(Uzbekistan stainless steel cylinder,produced by Hengyu Hydraulic Cylinder Factory）

stainless steel cylinder are widely used in Uzbekistan，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed stainless steel cylinder for customers from Uzbekistan.

Introduction to stainless steel cylinder:

In use, the stainless steel cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the stainless steel cylinder.

The main role of the stainless steel cylinder: the stainless steel cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the stainless steel cylinder realizes reciprocating motion. The structure of the stainless steel cylinder has three categories: piston stainless steel cylinder, plunger stainless steel cylinder, swing stainless steel cylinder, piston stainless steel cylinder and plunger stainless steel cylinder to achieve reciprocating linear motion, output speed and thrust, swing stainless steel cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the stainless steel cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The stainless steel cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

The daily inspection of the stainless steel cylinder includes: checking the connection of the stainless steel cylinder and the pipe joint for leaks. Check the stainless steel cylinder rod for leaks. Check the stainless steel cylinder connection for leaks. When the stainless steel cylinder moves, the work is normal and smooth. Whether the stainless steel cylinder has internal leakage.

Disassembly stainless steel cylinder: When disassembly stainless steel cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the stainless steel cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the stainless steel cylinder.

Answers to some questions about stainless steel cylinder:

What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.

What causes hydraulic cylinder oil leakage?
1. Internal leakage (1) The wear ring on the piston is seriously worn, leading to friction between the piston and the cylinder liner, and finally strain the cylinder liner, piston and seal; 2) Seal long-term use failure, piston seal (mostly U, V, Y ring, etc.) aging; 3) The hydraulic oil is dirty, and a large number of impurities enter the cylinder and wear the piston seal to bad; 2. External leakage 1) cylinder inlet and outlet tubing joint cracking; (This I see in the actual work is still more) 2) The piston rod extension end with the piston rod seal damage, mostly due to the piston cylinder is caused by hair, but also caused by aging; 3) The seal between the extended end of the piston rod and the liner is damaged.