track steering cylinder Sold to S.Africa

This article mainly introduces:

S.Africa hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(S.Africa track steering cylinder,produced by Hengyu Hydraulic Cylinder Factory）

track steering cylinder are widely used in S.Africa，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed track steering cylinder for customers from S.Africa.

Introduction to track steering cylinder:

The track steering cylinder should be used correctly and maintained regularly. The track steering cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the track steering cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

The pressure of the sliding surface of the track steering cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the track steering cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

If the seal of the track steering cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

The coordination of the sliding parts of the track steering cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

Answers to some questions about track steering cylinder:

What is a differential cylinder?
The differential cylinder is by connecting the return oil of the rod cavity through the pipeline, allowing them to flow into the rodless cavity, thereby speeding up the extension speed of the piston rod. In fact, the cylinder is still the cylinder, but the oil circuit is related to the connection. The oil connection mode in which both chambers of a single rod hydraulic cylinder are fed hydraulic oil is called differential connection.

What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.