servo cylinder Sold to Costa Rica

This article mainly introduces:

Costa Rica hydraulic cylinder,servo cylinder manufacturer,servo cylinder

(Costa Rica servo cylinder,produced by Hengyu Group）

servo cylinder are widely used in Costa Rica，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed servo cylinder for customers from Costa Rica.

Introduction to servo cylinder:

The servo cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the servo cylinder should pay attention to: the operation should be as far away from the servo cylinder as possible, to avoid falling objects, knocking, rubbing the servo cylinder coating. When cleaning the servo cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the servo cylinder when the oil temperature exceeds 70 ° C.

Repair method of small range wear of oil servo cylinder: 1. Use oxygen-acetylene flame to bake the scratched part (master the temperature, avoid surface annealing), bake the oil on the metal surface all the year round until no sparks splash; 2. The scratched part is treated with an Angle grinder, the grinding depth is more than 1 mm, and the groove is polished along the guide rail, preferably a dovetail groove. Scratch both ends of the drilling deeper, change the force situation; 3. Clean the surface with absorbent cotton dipped in acetone or anhydrous ethanol.

Because of the slightly complex structure of the buffer servo cylinder, sometimes there will be problems, such as when the servo cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

The piston rod of the servo cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.

Answers to some questions about servo cylinder:

How to distinguish the size of hydraulic cylinder cavity?
The hydraulic cylinder has a rod cavity and a rodless cavity. The rod cavity is the cavity that the piston rod extends out. The rod cavity is of course small due to the existence of the piston rod. That's just relative.

What is the material of the cylinder support ring?
Generally, it is polytetrafluoroethylene doped with copper powder, or polyformaldehyde, and copper sleeves, there are also nylon, resin and so on.