self-locking hydraulic cylinder Sold to Tanzania

This article mainly introduces:

Tanzania hydraulic cylinder,self-locking hydraulic cylinder manufacturer,self-locking hydraulic cylinder

(Tanzania self-locking hydraulic cylinder,produced by Hengyu Group）

self-locking hydraulic cylinder are widely used in Tanzania，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed self-locking hydraulic cylinder for customers from Tanzania.

Introduction to self-locking hydraulic cylinder:

At the rated pressure, the thrust of the self-locking hydraulic cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the self-locking hydraulic cylinder is related to the diameter of the self-locking hydraulic cylinder, but not to the stroke of the self-locking hydraulic cylinder. Moreover, the larger the self-locking hydraulic cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the self-locking hydraulic cylinder.

The self-locking hydraulic cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the self-locking hydraulic cylinder should pay attention to: the operation should be as far away from the self-locking hydraulic cylinder as possible, to avoid falling objects, knocking, rubbing the self-locking hydraulic cylinder coating. When cleaning the self-locking hydraulic cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the self-locking hydraulic cylinder when the oil temperature exceeds 70 ° C.

The viscosity of the working oil used in the self-locking hydraulic cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

The self-locking hydraulic cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

Answers to some questions about self-locking hydraulic cylinder:

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.

How big is the 100t cylinder pump and how big is the motor?
Load is calculated at 15 tons, stroke is calculated at 100 (both take the maximum) 15 tons = 15,000 kg, 15,000/210 bar (21 mpa) =71.42 square centimeters (cylinder area) 71.42/3,14 In the root *2=90,5 the inner diameter of the cylinder can be taken 100 mm. Travel 100 cm, that is, one meter, assuming 10, seconds a back and forth, then it is six times a minute, six meters per minute, then the required flow is,71,42*600 cm (6 meters) =42840 mm =42.84 liters/minute 42.84*21/60=14.9 kilowatts can choose 1450 RPM 4-stage motor 15KW.