lifting platform cylinder Sold to Cote d 'Ivoire

This article mainly introduces:

Cote d 'Ivoire hydraulic cylinder,lifting platform cylinder manufacturer,lifting platform cylinder

(Cote d 'Ivoire lifting platform cylinder,produced by Hengyu Hydraulic Cylinder Factory）

lifting platform cylinder are widely used in Cote d 'Ivoire，because of long service life，smooth movement，high work efficiency.So our company has designed lifting platform cylinder for customers from Cote d 'Ivoire.

Introduction to lifting platform cylinder:

The lifting platform cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the lifting platform cylinder, bite. Elimination method: When installing the lifting platform cylinder, ensure that the axis position of the lifting platform cylinder is consistent with the direction of movement; Make the load borne by the lifting platform cylinder as far as possible through the lifting platform cylinder axis, to avoid the phenomenon of eccentricity.

The viscosity of the working oil used in the lifting platform cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

When using the lifting platform cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the lifting platform cylinder block. If the lifting platform cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the lifting platform cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the lifting platform cylinder, so that the working efficiency of the lifting platform cylinder is reduced.

If the lifting platform cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

Answers to some questions about lifting platform cylinder:

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).

How to take out the diaphragm of hydraulic cylinder? The septum ring is also known as the septum sleeve, when the cylinder is too long, and does not need too much travel, add the septum sleeve, limit the stroke of the hydraulic cylinder, set on the piston rod, only contact with the guide sleeve and piston, do not cooperate with the cylinder, limit the stroke, take out the difficulty is different, need to have such a professional tool, before taking out to consult the manufacturer.