yg series hydraulic cylinder Sold to Sudan

This article mainly introduces:

Sudan yg series hydraulic cylinder,yg series hydraulic cylinder manufacturer

(Sudan yg series hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

yg series hydraulic cylinder are widely used in Sudan，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed yg series hydraulic cylinder for customers from Sudan.

Introduction to yg series hydraulic cylinder:

The piston rod and guide sleeve function of the yg series hydraulic cylinder is crucial: the relative motion pair between the piston rod and the guide sleeve is the main factor causing external leakage, if the chrome layer on the surface of the piston rod is spalling or producing longitudinal tensile marks due to wear, it will directly lead to the failure of the seal.

The definition of the minimum starting pressure of the yg series hydraulic cylinder refers to the minimum working pressure of the yg series hydraulic cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the yg series hydraulic cylinder parts and the size of the sealing friction.

Do not regularly check the damage of the chrome layer of the yg series hydraulic cylinder: completely extend the yg series hydraulic cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the yg series hydraulic cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the yg series hydraulic cylinder seal. Welding slag is strictly prohibited on the surface of the yg series hydraulic cylinder.

Do not enter foreign bodies when installing the yg series hydraulic cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

Answers to some questions about yg series hydraulic cylinder:

What is the cause of the sound of the excavator arm cylinder?
Hydraulic excavator cylinder includes boom cylinder, bucket rod cylinder and bucket cylinder, four cylinders. The sound of boom cylinder may be the wear of hydraulic cylinder block bushing, piston rod bushing and shaft pin. The main reason: poor lubrication, followed by improper clearance in the assembly process. Countermeasures: (1) Strictly lubricate each shaft pin at least once every 8 hours when the excavator is initially used for 100 hours and under harsh conditions; In other working conditions, lubricate each pin at least once every 50 hours. (2) If the lubricating oil passage is found to be blocked, it must be stopped for rectification. (3) Require assembly, replacement of all parts of the shaft pin, bushing strictly comply with the assembly testing standards and operating procedures.

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.