unidirectional cylinder Sold to Cameroon

This article mainly introduces:

Cameroon hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

(Cameroon unidirectional cylinder,produced by Hengyu Hydraulic Co., Ltd）

unidirectional cylinder are widely used in Cameroon，because of no need for deceleration device，long service life，no transmission clearance.So our company has designed unidirectional cylinder for customers from Cameroon.

Introduction to unidirectional cylinder:

The pressure, temperature, medium and speed of different types of seals are not the same, water-ethylene glycol medium (HFC) can not be sealed with polyurethane, it can only use rubber seal; When the unidirectional cylinder is running fast, it must be sealed with slip ring, such as Sterseal, Glairing, GD1000K, TDI, etc., when the running speed is slow, Yx, U, V combination seals can be used; Fluorine rubber seal is used in high temperature and high pressure environment; When the running speed is fast, the buffer sleeve and buffer valve must be considered.

When the unidirectional cylinder is installed, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the unidirectional cylinder head, earring (or middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent rigid interference and cause unnecessary damage.

unidirectional cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards unidirectional cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the unidirectional cylinder guide is determined by the length of the stroke. Check the strength of unidirectional cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

Disassembly unidirectional cylinder: When disassembly unidirectional cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the unidirectional cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the unidirectional cylinder.

Answers to some questions about unidirectional cylinder:

When does the cylinder rotate?
The piston rod inside the multistage plunger cylinder can be rotated, and it will rotate when it is subjected to tangential force.

Hydraulic cylinder load algorithm?
If it is thrust, load = working pressure x piston area. If it is pulling force, load = working pressure x(piston area - piston rod area).