clamp type cylinder Sold to Kenya

This article mainly introduces:

Kenya hydraulic cylinder,clamp type cylinder manufacturer,clamp type cylinder

(Kenya clamp type cylinder,produced by Hebei Hengyu company）

clamp type cylinder are widely used in Kenya，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed clamp type cylinder for customers from Kenya.

Introduction to clamp type cylinder:

Piston clamp type cylinder is widely used in hydraulic transmission. When the clamp type cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the clamp type cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the clamp type cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

In order to ensure the service life of the clamp type cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

When the control pressure of the hydraulic system is too low, the clamp type cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

clamp type cylinder use should try to avoid sealing belt into the clamp type cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the clamp type cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the clamp type cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

Answers to some questions about clamp type cylinder:

The hydraulic cylinder is slow when moving forward and faster when moving back.
If the cylinder is single, it is slow when it is moving forward without the rod cavity, and fast when it is shrinking.

The difference between the overall cylinder and the separate cylinder of the truck?
The whole cylinder is cast in one piece, and such a cylinder generally does not leak oil. Split cylinder refers to two welded, easy to leak oil in the welding place, resulting in damage to the cylinder, or its body can not get up, many people do not use this kind of cylinder now.