steering power cylinder Sold to Slovenia

This article mainly introduces:

Slovenia hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Slovenia steering power cylinder,produced by Hengyu Group）

steering power cylinder are widely used in Slovenia，because of simple structure and reliable operation，clever hydraulic energy conversion，excellent fatigue and impact resistance.So our company has designed steering power cylinder for customers from Slovenia.

Introduction to steering power cylinder:

Before the steering power cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

When the hydraulic oil is not pumped into the steering power cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the steering power cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

When the piston speed of the steering power cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the steering power cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

steering power cylinder hydraulic oil selection: The recommended working oil viscosity of the steering power cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

Answers to some questions about steering power cylinder:

Does the abbreviation bc stand for bucket cylinder or boom cylinder?
Hydraulic excavator hydraulic cylinder includes boom cylinder, bucket rod cylinder and bucket cylinder three parts, four cylinders. Because of the different naming conventions of major manufacturers, the meaning of BC is also different, for the sake of insurance, you need to consult the manufacturer.

By what means can the hydraulic system control the arbitrary stroke position of the rotary cylinder piston rod?
The following ways can be considered: 1, through the limit device, such as limit switch, position sensor, etc. 2, by feedback the pressure of the hydraulic oil in the cylinder. The load determines the pressure, the pressure in the cylinder is determined by the load, and the pressure is very small when the cylinder is unloaded. 2.1 When clamping the workpiece, the pressure of the cylinder increases, by calculating the relationship between the clamping force and the pressure of the cylinder, take a pressure value of the cylinder, set the pressure switch, and drive the valve to work when the pressure reaches the preset value, so that the oil circuit stops supplying oil. 2.2 or set the pressure value of the relief valve to overflow after a certain set pressure.