swager cylinder Sold to America

This article mainly introduces:

America hydraulic cylinder,swager cylinder manufacturer,swager cylinder

(America swager cylinder,produced by Hengyu Hydraulic Cylinder Factory）

swager cylinder are widely used in America，because of no need for deceleration device，long service life，smooth movement.So our company has designed swager cylinder for customers from America.

Introduction to swager cylinder:

swager cylinder can not drive the load troubleshooting: oil pressure is too low. swager cylinder selection specifications are too small. Leakage in swager cylinder or associated hydraulic system element.

After chrome plating of the piston rod of the swager cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

swager cylinder and hydraulic station selection: Select the type and structure of the swager cylinder according to the operation requirements of the main engine. According to the external load force borne by the swager cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the swager cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the swager cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the swager cylinder, the diameter of the piston and the piston rod.

The definition of the minimum stable speed refers to the minimum movement speed of the swager cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the swager cylinder that undertakes different work has different requirements for the minimum stable speed.

Answers to some questions about swager cylinder:

What hydraulic oil does servo cylinder generally use?
The medium used by the cylinder generally depends on the working condition of the use, including pressure, installation environment, sealing material, etc. I think the first thing to consider is the impact of the sealing material. Mineral oil is a good choice if it is not too fire-resistant or used in a high temperature environment. 1, servo cylinder features: closed-loop servo control, control accuracy of 0.01mm; Precise control of thrust, increase pressure sensor, control accuracy up to 1%; It is easy to connect with PLC and other control systems to achieve high precision motion control. Low noise, energy saving, clean, high rigidity, impact resistance, long life, simple operation and maintenance. 2, the servo cylinder can be fault-free in harsh environments, and the protection level can reach IP66.

How to exhaust hydraulic cylinder?
Exhaust: The hydraulic system generally does not have exhaust, the use of the tank can exhaust, the oil operation will bring the gas back to the tank, and the tank can be communicated with the atmosphere. The gas will escape from the oil.